VPI Industries JMW-9T Manuel d'utilisateur télécharger pdf (Page 2)

BEFORE YOU BEGIN

NOT FOLLOWING THIS MANUAL WILL VOID YOUR WARRANTEE.

FAILURE TO SEND IN THE WARRANTEE CARD WILL VOID YOUR WARRANTEE.

1. Be very careful when handling the tone arm. The internal arm wire is exposed at the

headshell and at the rear of the arm. This wire is very delicate and contains Nordost Valhalla

wiring. Physical damage to the wire is not covered by the warranty after the arm is removed

from its box.

2. Please do not touch the unipivot bearing parts. Finger oils on the bearing cup in the upper

bearing housing or on the lower pivot point in the arm base assembly can cause blemishing of

the bearing and possible corrosion. Also, the point is sharp, be careful.

3. There are a number of setscrews on the JMW Memorial Tone Arm. The Allen wrenches that

come with your arm will only fit the setscrews that you will need to adjust. All other screws

are factory set and should not be adjusted, except by our trained technicians. Resetting any

of the factory settings is not covered by the warranty.

UNPACKING YOUR JMW MEMORIAL TONE ARM

 This instruction manual was lying on a large foam pad. Remove the pad and put it nearby on

your work surface.

 You will now see a number of things in plastic bags:

 Allen wrenches

 Hex nuts, and washers (for cartridge mounting)

 Arm mounting and alignment tool

 Shure stylus gauge

 Damping fluid

 Take all these items out and set them aside. Be careful with the damping fluid. It

should be kept sealed until it is used.

A. CARTRIDGE MOUNTING:

 Remove the arm tube from the box (taking special care not to strain or damage, the delicate

4-color wire and Lemo connector) and place it right side up on the foam pad.

 FOR CARTRIDGES WITH THREADED MOUNTING HOLES Use the screws supplied by the

cartridge manufacturer to mount the cartridge. Any other screws may not fit the thread

properly and may even damage the threads and cartridge. USE ONE OF THE SUPPLIED

WASHERS UNDER THE SCREW HEAD.

 For all cartridges with pass through mounting holes use the hardware supplied with the arm.

Remember to use the washers under the screw heads to prevent damage to the finish on the

JMW arm. In this step, the connectors will be attached to the cartridge's terminals.

Disregard the color of the insulators on the cartridge clips.

1 2 3 4 5 6 7

Pas de commentaire

VPI Industries JMW-9T Manuel d'utilisateur Page 2